NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

160 Description of Parameters Honeywell
402 Reducing of torque supervision limit 6 (2.2.6.4)
See ID399.
The set torque supervision limit can
be reduced with the free analogue
input signal between 0 and the set
supervision limit, ID349. See Figure
8-39.
100%
Par. ID349
Torque
limit
403 Start signal 1 6 (2.2.7.1)
Signal selection 1 for the start/stop logic.
Default programming A.1.
404 Start signal 2 6 (2.2.7.2)
Signal selection 2 for the start/stop logic.
Default programming A.2.
405 External fault (close) 67 (2.2.7.11, 2.2.6.4)
Contact closed:
Fault is displayed and motor stopped.
406 External fault (open) 67 (2.2.7.12, 2.2.6.5)
Contact open:
Fault is displayed and motor stopped.
407 Run enable 67 (2.2.7.3, 2.2.6.6)
Contact open:
Contact closed:
Start of motor disabled
Start of motor enabled
Signal
range
Free
analogue
input
0 NX12K60
Figure 8-39. Reducing torque supervision limit
408 Acceleration/Deceleration time selection 67 (2.2.7.13, 2.2.6.7)
Contact open:
Contact closed:
Acceleration/Deceleration time 1 selected
Acceleration/Deceleration time 2 selected
Set Acceleration/Deceleration times with parameters ID103 and ID104.
409 Control from I/O terminal 67 (2.2.7.18, 2.2.6.8)
Contact closed:
Force control place to I/O terminal
410 Control from keypad 67 (2.2.7.19, 2.2.6.9)
Contact closed:
Force control place to keypad
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com