NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

48(110) Cabling and connections
6.1.5 Installation instructions
1
Before starting the installation, check that none of the components of the
frequency drive are live.
2
Place the motor cables sufficiently far from other cables:
• Avoid placing the motor cables in long parallel lines with other
cables
• If the motor cables runs in parallel with other cables, note the
minimum distances between the motor cables and other cables
given in the table below.
• The given distances also apply between the motor cables and
signal cables of other systems.
• The maximum length of the motor cables is 984 ft (, units with
power greater than 2.01 HP) and 327 ft (units with power from 1 to
2.01 HP).
• The motor cables should cross other cables at an angle of 90
degrees.
3
If cable insulation checks are needed, see Chapter 6.1.7.
Continues on the next page
6
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com