NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Honeywell Description of Parameters 161
411 Control from fieldbus 67 (2.2.7.20, 2.2.6.10)
Contact closed:
Force control place to fieldbus
NOTE: When the control place is forced to change the values of Start/Stop, Direction
and Reference valid in the respective control place are used.
The value of parameter ID125 (Keypad Control Place) does not change.
When the input opens the control place is selected according to keypad control
parameter ID125.
412 Reverse 67 (2.2.7.4, 2.2.6.11)
Contact open:
Contact closed:
Direction forward
Direction reverse
413 Jogging speed 67 (2.2.7.16, 2.2.6.12)
Contact closed: Jogging speed selected for frequency reference
See parameter ID124.
Default programming: A.4.
414 Fault reset 67 (2.2.7.10, 2.2.6.13)
Contact closed:
All faults are reset.
415 Acceleration/Deceleration prohibited 67 (2.2.7.14, 2.2.6.14)
Contact closed:
No acceleration or deceleration possible until the contact is opened.
416 DC-braking 67 (2.2.7.15, 2.2.6.15)
Contact closed:
In STOP mode, the DC braking operates until the contact is opened.
417 Motor potentiometer DOWN 67 (2.2.7.8, 2.2.6.16)
Contact closed:
opened.
Motor potentiometer reference DECREASES until the contact is
418 Motor potentiometer UP 67 (2.2.7.9, 2.2.6.17)
Contact closed:
opened.
Motor potentiometer reference INCREASES until the contact is
419 Preset speed 1 6 (2.2.7.5)
420 Preset speed 2 6 (2.2.7.6)
421 Preset speed 3 6 (2.2.7.7)
Parameter values are automatically limited between the minimum and maximum
frequencies (parameters ID101 and ID102).
422 AI1/AI2 selection 6 (2.2.7.17)
With this parameter you can select either AI1 or AI2 signal for frequency reference.
423 Start A signal 7 (2.2.6.1)
Start command from control place A.
Default programming: A.1
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com