NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

188 Description of Parameters Honeywell
738 Automatic restart: Number of tries after underload fault trip (2.8.10)
This parameter determines how many automatic restarts can be made during the trial
time set by parameter ID718.
0 = No automatic restart after Underload fault trip
>0 = Number of automatic restarts after Underload fault trip
739 Number of PT100 inputs in use 567 (2.7.24)
If you have a PT100 input board installed in your frequency drive you can choose here
the number of PT100 inputs in use. See also the I/O boards manual.
Note: If the selected value is greater than the actual number of used PT100 inputs, the
display will read 200ºC. If the input is short-circuited the displayed value is –30ºC.
740 Response to PT100 fault 567 (2.7.25)
0 = No response
1 = Warning
2 = Fault, stop mode after fault according to ID506
3 = Fault, stop mode after fault always by coasting
741 PT100 warning limit 567 (2.7.26)
Set here the limit at which the PT100 warning will be activated.
742 PT100 fault limit 567 (2.7.27)
Set here the limit at which the PT100 fault (F56) will be activated.
750 Cooling monitor 6 (2.2.7.23)
When using a water-cooled drive, connect this input to the Cooling OK signal from flow
control application. The parameter is available for NXP drives only.
751 Cooling fault delay
The delay after the motor is stopped with coasting after the cooling OK signal is missing.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com