NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

Control keypad 73(110)
7
start
stop
= Start button.
Pressing this button starts the motor if the keypad is the active control
place. See Chapter 7.3.3.1.
= Stop button.
Pressing this button stops the motor (unless disabled by parameter
R3.4/R3.6).
7.3 Navigation on the control keypad
The data on the control keypad are arranged in menus and submenus. The menus are used for
example for the display and editing of measurement and control signals, parameter settings
(chapter 7.3.2), reference values and fault displays (chapter 7.3.4). Through the menus, the
contrast of the display (page 96) can be adjusted.
Location
Description
Number of items
available; Item value
Local
STOP
READY
Monitor
V1V14
The first menu level consists of menus M1 to M7 and is called the Main menu. The user can
navigate in the main menu using the Browser buttons up and down. The desired submenu can be
entered from the main menu using the Menu buttons. When there still are pages to enter under
the currently displayed menu or page, an arrow ( ) can be seen in the lower right corner of the
display and by pressing the right arrow menu button, the next menu level can be reached.
The control keypad navigation chart is shown on the next page. Please note that the menu M1 is
located in the lower left corner. From there it is possible to navigate your way up to the desired
menu using the menu and browser buttons.
More detailed descriptions of the menus can be found later in this Chapter.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com