NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

5
24(110) Installation
5. INSTALLATION
5.1 Mounting
The frequency drive should be fixed with four fasteners sized appropriately to support the full
weight of the unit and all approved accessories. Enough space shall be reserved around the
frequency drive in order to ensure a sufficient cooling, see Figure 5-10, Table 5-9 and Table 5-10.
For safe installation, ensure that the mounting surface is relatively even.
The frequency drive should be fixed with four screws (or bolts, depending on the unit size). The
dimensions of installation are presented in Figure 5-10 and Table 5-9.
Lift units bigger than FR7 out of the package using a jib crane. Ask the factory or your local
distributor for information on how to lift the unit safely.
Below are the dimensions of the NX frequency drives with NEMA1 enclosure in Figure 5-1 and
with NEMA1 for collar installation in Figure 5-2 and Figure 5-4. The dimensions of the opening
needed in collar installation are given in Table 5-3 and Table 5-5.
The sizes FR10 to FR12 are floorstanding units. The enclosures are equipped with fixing holes.
For dimensions see below.
See also chapter 5.2 Cooling.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com