NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

178 Description of Parameters Honeywell
641 Torque reference selection 6 (2.10.3)
Defines the source for torque reference.
0 Not used
1 Analogue input 1
2 Analogue input 2
3 Analogue input 3
4 Analogue input 4
5 Analogue input 1 (joystick)
6 Analogue input 2 (joystick)
7 From keypad, parameter R3.5
8 Fieldbus torque reference
642 Torque reference scaling, maximum value 6 (2.10.4)
643 Torque reference scaling, minimum value 6 (2.10.5)
Scale the custom minimum and maximum levels for analogue inputs within
-300,0…300,0%.
644 Torque speed limit, NXS 6 (2.10.6)
With this parameter the maximum frequency for the torque control can be selected.
0 Maximum frequency
1 Selected frequency reference
2 Preset speed 7
NXP drives have more selections for this parameter. See page 204.
645 Negative torque limit 6 (2.6.27.21)
646 Positive torque limit 6 (2.6.27.22)
Defines the torque limit for positive and negative directions.
649 PMS motor shaft position 6 (2.6.28.4)
Identified zero shaft position when using absolute encoder for PMS motor.
650 Motor type 6 (2.6.28.1)
Select used motor type with this parameter.
0 Induction motor
1 Permanent magnet synchronous motor
654 Enable Rs identification 6 (2.6.28.5)
Stator resistance identification at start.
0 No
1 Yes
655 Modulator index limit
This parameter can be used to increase motor voltage in field weakening area.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com