NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

162 Description of Parameters Honeywell
424 Start B signal 7 (2.2.6.2)
Start command from control place B.
Default programming: A.4
425 Control place A/B selection 7 (2.2.6.3)
Contact open: Control place A
Contact closed: Control place B
Default programming: A.6
426 Autochange 1 interlock 7 (2.2.6.18)
Contact closed: Interlock of autochange drive 1 or auxiliary drive 1 activated.
Default programming: A.2.
427 Autochange 2 interlock 7 (2.2.6.19)
Contact closed: Interlock of autochange drive 2 or auxiliary drive 2 activated.
Default programming: A.3.
428 Autochange 3 interlock 7 (2.2.6.20)
Contact closed:
Interlock of autochange drive 3 or auxiliary drive 3 activated.
429 Autochange 4 interlock 7 (2.2.6.21)
Contact closed:
Interlock of autochange drive 4 or auxiliary drive 4 activated.
430 Autochange 5 interlock 7 (2.2.6.22)
Contact closed:
Interlock of autochange drive 5 activated.
431 PID reference 2 7 (2.2.6.23)
Contact open:
Contact closed:
PID controller reference selected with parameter ID332.
PID controller keypad reference 2 selected with par. ID371.
432 Ready 67 (2.3.3.1, 2.3.1.1)
The frequency drive is ready to operate.
433 Run 67 (2.3.3.2, 2.3.1.2)
The frequency drive operates (the motor is running).
434 Fault 67 (2.3.3.3, 2.3.1.3)
A fault trip has occurred.
Default programming: A.1.
435 Inverted fault 67 (2.3.3.4, 2.3.1.4)
No fault trip has occurred.
436 Warning 67 (2.3.3.5, 2.3.1.5)
General warning signal.
437 External fault or warning 67 (2.3.3.6, 2.3.1.6)
Fault or warning depending on par. ID701.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com