NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

22 Local/Remote Control Application Honeywell
3. LOCAL/REMOTE CONTROL APPLICATION
3.1 Introduction
Select the Local/Remote Control Application in menu M6 on page S6.2.
Utilising the Local/Remote Control Application it is possible to have two different control places. For
each control place the frequency reference can be selected from either the control keypad, I/O
terminal or fieldbus. The active control place is selected with the digital input DIN6.
• All outputs are freely programmable.
Additional functions:
• Programmable Start/Stop and Reverse signal logic
• Reference scaling
• One frequency limit supervision
• Second ramps and S-shape ramp programming
• Programmable start and stop functions
• DC-brake at stop
• One prohibit frequency area
• Programmable U/f curve and switching frequency
• Autorestart
• Motor thermal and stall protection: Programmable action; off, warning, fault
The parameters of the Local/Remote Control Application are explained in Chapter 8 of this manual.
The explanations are arranged according to the individual ID number of the parameter.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com