NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

204 Description of Parameters Honeywell
1276 Emergency stop mode 6 (2.4.21)
Defines the action after the IO emergency input goes low. The parameter is available for
NXP drives only.
0 Coasting stop
1 Ramping stop
1278 Torque speed limit, Closed Loop 6 (2.10.6)
With this parameter the maximum frequency for the torque control can be selected.
0 Closed Loop speed control
1 Positive and negative frequency limit
2 Ramp generator output (-/+)
3 Negative frequency limit – Ramp generator output
4 Ramp generator output – Positive frequency limit
5 Ramp generator output with window
6 0 – Ramp generator output
7 Ramp generator output with window and On/Off limits
For the selection of this parameter in NXS drives, see page 178.
1285 Positive frequency limit 6 (2.6.20)
Maximum frequency limit for the drive. The parameter is available for NXP drives only.
1286 Negative frequency limit 6 (2.6.19)
Minimum frequency limit for the drive. The parameter is available for NXP drives only.
1287 Motoring torque limit 6 (2.6.22)
Defines the maximum motoring side torque limit. The parameter is available for NXP
drives only.
1288 Generator torque limit 6 (2.6.21)
Defines the maximum generating side torque limit. The parameter is available for NXP
drives only.
1289 Motoring power limit 6 (2.6.27.20)
Defines the maximum motoring side power limit.
1290 Generator power limit 6 (2.6.27.19)
Defines the maximum generating side power limit.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com