NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

166 Description of Parameters Honeywell
484 Analogue output 3 offset 67 (2.3.7.7, 2.3.5.7)
See ID375.
485 Scaling of motoring torque limit 6 (2.2.6.5)
See par. ID399 for the selections.
486 Digital output 1 signal selection 6 (2.3.1.1)
Connect the delayed DO1 signal to the digital output of your choice with this parameter.
For more information about the TTF programming method, see chapter 6.4. Digital
output function can be inverted by Control options, par. ID1084.
487 Digital output 1 on-delay 6 (2.3.1.3)
488 Digital output 1 off-delay 6 (2.3.1.4)
With these parameters you can set on- and off-delays to digital outputs.
Signal programmed to
digital output
DO1 or DO2 output
ON-delay
OFF-delay
Figure 8-40. Digital outputs 1 and 2, on- and off-delays
NX12k102
489 Digital output 2 signal selection 6 (2.3.2.1)
See ID486.
490 Digital output 2 function 6 (2.3.2.2)
See ID312.
491 Digital output 2 on-delay 6 (2.3.2.3)
See ID487.
492 Digital output 2 off-delay 6 (2.3.2.4)
See ID488.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com