NXS Form 63-2600, Users Manual, Technical Data - CONTROL ...

158 Description of Parameters Honeywell
388 AI2 signal selection 234567 (2.2.9, 2.2.21, 2.2.3.1)
Connect the AI2 signal to the analogue input of your choice with this parameter. For
more information about the TTF programming method, see chapter 6.4.
393 AI2 reference scaling, minimum value 6 (2.2.3.6)
394 AI2 reference scaling, maximum value 6 (2.2.3.7)
See ID’s 303 and 304.
395 AI2 joystick hysteresis 6 (2.2.3.8)
See ID384.
396 AI2 sleep limit 6 (2.2.3.9)
See ID385.
397 AI2 sleep delay 6 (2.2.3.10)
See ID386.
399 Scaling of current limit 6 (2.2.6.1)
0 = Not used
1 = AI1
2 = AI2
3 = AI3
4 = AI4
5 = Fieldbus (FBProcessDataIN2)
This signal will adjust the maximum motor current between 0 and max. limit set with
parameter ID107.
Automation and Control Solutions
Honeywell
Honeywell Limited-Honeywell Limitée
1985 Douglas Drive North 35 Dynamic Drive
Golden Valley, MIN 55422 Scarborough, Ontario 63-2600-1
MIV 4Z9
www.honeywell.com