Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

816 Fault FindingMenu 40: Program multiflexMenu 41: Level Allocation = Level A,B,C,D = NoneMenu 42: Level Exit Mode = All Levels = Timed and terminate (ExitTime = 10 Seconds)Menu 43: Level Entry Time = All Levels 20 SecondsMenu 44: Level Flexi-Zones = Not Set Up = NUMenu 45: Level Alarm response = All Levels = Full AlarmMenu 46: Level Re-Arms response = All Levels = NeverMenu 47: Keypad allocation = NoneMenu 50: Program outputsMenu 51: Output Types = OP1 = Bell (Normally Energised). OP2 =Strobe (Normally De- Energised) All other NO FunctionMenu 52: Internal sounder = Follows BellMenu 53: Global Bell times = Delay = 0, Bell Time = 20 MinutesMenu 60: Program System OptionsMenu 61: Installer information = Code = 7890Menu 62: PA response = AudibleMenu 63: Line Fault response = AudibleMenu 64: Allow Zone omits = DisabledMenu 65: System reset = CustomerMenu 66: Serial Port = PrinterMenu 67: Miscellaneous = First Circuit = Re-arm,Entry Abort = Disabled,Tampers Comms = Disabled, SetNO Mains = Disabled, Reset No Mains = DisabledAlarm Confirmation = DisabledAlarm Abort = DisabledWhen the installer resets defaults using the RST pins, the system alsochanges the following items:Installer Code 07890User Code 1234Fault FindingGeneral FaultsNo response from the keypad keys.• Check the keypad wiring.• Check the keypad address programming.• Enter and leave programming mode.• Power up while shorting RST pins.OBSOLETE PRODUCT496337 Issue 1 19 of 22