Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

4618 Site CodesSite CodesYou must set the 46RX family receiver and the transmitters to the same sitecode. The 46RX family receiver will only respond to signals from a transmitterset to the correct site code.For some modes the site code to set for the transmitters is shorter than thesite code set on the 46RX family receiver. The Mode Details section givesthe correct number of switches to set on the transmitter.Mode SwitchTo set the 46RX family receiver into the desired mode, set switches 4 to 8 ofthe Mode Switch into the correct pattern. The pattern for each mode is shownin the Mode Details section of this Chapter. Note that switch 1 (Self Test)should always be OFF.Transmitters and Trigger DevicesThis sub-section describes how individual transmitters signal the state of theirtrigger devices. Consult the instructions provided with each transmitter formore details on installing and using the transmitters.Each type of transmitter uses one or more channels to send information tothe receiver. For example, a personal attack button might use one channel,but a door contact sensor might use two: one for door open/closed and onefor tamper reporting.For two channel transmitters this guide calls the channel normally used foralarm reporting "channel A", and the channel used for tamper reporting"channel B". Single channel transmitters have the equivalent of channel Aonly.Four channel transmitters have the equivalent of A, B, C, and D channels.Transmitters send one of two signals over individual channels: ACTIVE orRESTORE. Some transmitters send an ACTIVE signal every time the detectoris activated (for example a pendant panic button). Other transmitters sendan ACTIVE signal when the detector is activated in one direction, and aRESTORE signal when the detector is activated in the other direction (forexample a door contact).To make sure the 46RX family receiver indicates correctly which transmitterhas signalled, you must set the appropriate switches within the transmitter toa channel or device number. The Mode Details section tells you whichswitches to set in the transmitter to obtain the correct device numbers. Ignorethe switch settings suggested in the leaflets supplied with the transmitters(which are for use with other receivers). Use the switch settings suggested inthis Guide.496371 Issue 1 11 of 20