Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

95EN, 85EN, 65EN9950 – This keypad has a back-lit Liquid Crystal Display (LCD), a PowerLED, a programmable Function LED and a built-in proximity module.The proximity module enables users to enter their user code bypresenting a proximity tag or card. The keypad supports 3-resistoranti-masking zones.9951 – This is similar to the 9950, but without the proximity module.9953 – This is similar to the 9950, but has an extra connector for anexternal proximity reader.MSNodeThe MSNode provides eight zones and two programmable outputs (oneswitched positive and one switched negative). Each MSNode can also driveup to four keypads and two extension loudspeakers.The MSNode supports three-resistor anti-masking zones.MRNodeBy fitting one or more MRNodes to a system the installer can employ avariety of wirefree detectors to protect areas without running extra cabling. Inaddition, the user gains the ability to set and unset the system using radiotelecommands, or start panic alarms using PA transmitters. The MRNodeconnects to the control unit over the standard network cabling. The controlunit treats the wire free detectors as standard zones. Each MRNode cansupport up to eight detectors, plus any combination of telecommands or PAup to a maximum of eight devices.MSPSUThe MSPSU has an on-board power supply, which provides power fordevices connected to the MSPSU, or for other devices on the network. TheMSPSU also enables the system to be expanded by an extra eight zonesand one programmable output. The zones can connect to movementdetectors, smoke detectors, panic buttons or other sensors. You may alsoconnect up to four keypads and two extension loudspeakers to the MSPSU.Note: The MSPSU acts as an MSNode and can replace one of these nodes on thenetwork. Consequently, each MSPSU added reduces the allowable number ofMSNodes by one.WARNING: This device can contain mains voltages.CPA6 Output Module (not available on 65)The CPA6 Output Module provides eight switched-negative programmableoutputs rated at 100mA, which can be used to drive LEDs or relays, perhapsto give partition status information and/or zone alarm indications.8 of 72