Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5x90: Reading the Event Log6. TESTING COMMANDSThe control unit keeps a log of recent events. The log can contain up to 700events. Each event is described by a short text message. To review theevent log, make sure the system is in installer mode and then:1. Key in 90y.The display shows the most recent event in the log.2. Key in 1 to show earlier events or 3 to show later events.3. Key in 4 to show the first event or 6 to show the last event.4. Press X to leave the log.The table on the following pages shows the messages that can be recordedin the event log. Column 1 lists messages shown on the keypad displays andcolumn 2 lists corresponding messages in the printed log (9853 only). Eachevent in the printed log is preceded by the date and time in numerical format.To avoid multiple entries being made for the same fault condition, no morethan three events of the same type will be recorded for the same zone in thesame set period.Note: The log is protected and cannot be erased by the Installer or a user.In the log, users and devices are represented by numbers:U00 Installer U54 TelecommandU01 User 01 U55 KeyswitchU02 to U49/50 Users 02 to 49/50 U56 Remote resetU50 Guard code (if set up) U57 DownloadU51Duress codeU58 Virtual keypadU52Control unit(Downloader)U53 Idle U59 ForbikoblerPrinting the Event Log (9853 only)Note: 975x models do not have the connector required for event logprinting.To print the event log, make sure the system is in installer mode, and thenpress 90y0. To stop printing, press X.To toggle the logging printer on and off, press 90y7. The keypad gives a70 of 76 Issue 1