Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xCommandKey in:38 System Tamper38ynyUser/Engineer Resetn = 0 User reset after TamperAlarm1 Engineer reset afterYTamper Alarm39 Level/Partition A Exit Mode 39ynyn = In a single system:0 Timed low tone onYsetting1 Terminated (terminatedby button)2 Final Door (last door hasa detector)3 Lock Set (terminated bylock switch)In a partitioned system:0 Timed full tone onYsetting1 Terminated (terminatedby button)2 Final Door (last door hasa detector)3 Instant (no exit tone)4 Silent (double "beep"after exit time)5 Lock Set (terminated bylock switch)40 System Auto Rearm 40ynyn = 0 Rearm Never Y1 Rearm=1 (once)2 Rearm=2 (twice)3 Rearm=3 (three times)4 Rearm=AlwaysNote: C41 has no effect if C89 is set to 1 andany of the following applies: C162 is set to0, C161 is set to 0 or C47, C63, C73 or C77do not require communications.41 Bell Delay 41ynyn = 0 No delay Y1 1.5 minutesCommandKey in:2 3 minutes3 5 minutes4 10 minutes5 15 minutes6 20 minutes42 Bell Duration 42ynyn = 1 1.5 minutes2 3 minutes3 5 minutes4 10 minutes5 15 minutes Y6 20 minutes43 This command has beenreplaced by Command 201.44 Level/Partition A Exit Time 44ynyn = 1 10 seconds2 20 seconds Y3 30 seconds4 45 seconds5 60 seconds6 120 seconds45 Entry/Exit Tone Volume 45yny(In a partitioned system, thiscommand is available only forPartition A)n = 0 No Entry/Exit tone fromsoundern EE tone volume (1=low, 59=max)46 Tamper Alarm Response – 46ynysingle system onlyn = 0 Internal sounders only1 Keypad sounders only2 Internal and keypadsoundersYIssue 1 45 of 76