Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

Changing the User Code 500r+4. Remove the short after two seconds.5. Restore the mains supply.6. Close the lid.7. Enter 1234 and press Reset.Note: To restore all the programming apart from the learnt detectors, repeat steps 1to 7 above, but at 3. short together the top two LOAD DFLTS pins.Changing the User CodeYou can change the user access code while in programming mode. To dothis:1. Enter programming mode.2. Enter 7 2.The LEDs for zones 5, 6, 7 and 8 light up.3. Key in the new user code (four digits).Each time you key in a digit of the user access code one of the 5, 6, 7,or 8 LEDs goes out.4. Leave programming mode.Testing Detectors5. TestingMake sure the system is in programming mode.1. Enter 71.All LEDs light for 2 seconds, and then the control unit enters walk testmode.2. Activate each 502r, 525r (PA function only), and detector. You may alsotest detector tampers.When the control unit receives the detector it gives a chime tone andturns the relevant zone LED on for five seconds. The control unit turnson the Alarm and Tamper LEDs when you activate the tampers. Whenyou activate the 502r Watch Pendant or the PA function on the 525rRemote Setting Device the control unit gives a chime tone and lights thePA LED for five seconds.3. Press Reset to end the walk test.PIR Testing and LockoutIn normal use the 515r uses a three minute lockout timer in order to extendbattery life.The lockout timer works like this:10 of 14 496361 Issue 1