Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

8136 Configuration Checking Error MessagesAREA 04 NO PMeaning: Area Not Assigned to Partition. In the example shown, Area 04 hasa zone type programmed, but has not been assigned to a Partition.All programmed Areas must be Assigned to one Partition.Action: Check Menus 32 and 35.A2 IN P2 NO ZMeaning: Empty Area Assigned to Partition. In the example shown Area 2has been assigned to Partition 2, but there are no zones programmedto Area 2.Action: Check Menu 32.DUALPLY-V-DELAYMeaning: You have enabled both Dual Ply Entry and Bell Delay, with BellDelay always also enabled. This combination is not allowed.Action: Check Menus 67 and 53DUALPLY-V-ABORTMeaning: You have enabled both Dual Ply Entry and Alarm Abort at the sametime. Only one of these facilities should be enabled.Action: Check Menu 67.LEVEL B IN 2PMeaning: Level Assigned to Two Partitions. In the example shown Level Bincludes an Area that also belongs to more than one Partition.Action: Check Menus 35 and 41.A IN LC ERRORMeaning: Area Doesn’t Exist. In the example shown, Level C lists an Areawhich doesn’t exist.Action: Check Menu 41.LEVELSET O/P 12Meaning: Levelset Output Will Not Work. In the example shown, output 12 isa levelset output, but its assignment means that it will never work.Action: Check Menu 51.NO ZONES IN CAMeaning: No Zones In Common Area. There are no zones assigned to theCommon Area.Action: Check Menus 48 or 49.Z TYPE IN COM AMeaning: Flex Zone in Common Area. A Flexi-Zone has been assigned to theCommon Area. This is not allowed.Action: Check Menu 32.496339 Issue 4 31 of 44