Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xChime tone when the printer is turned on and a "beep beep" confirmationtone when the printer is turned off. This is a test mode and is cancelled ifpower is lost. Use Command 180 to turn printing on indefinitely.Figure 31 shows a sample of a printed log.– 9853 -14/12/01 18:42:30 Sounder TamperFigure 31. Sample Log PrintTo print a listing of the control unit's configuration, press 908yNote: The log is protected and cannot be erased by the Installer or a user.Event Log Messages* Printed event messages start with a time and date stamp.Keypad Display Printed (9853 only)* MeaningAC Fail AC Lost Mains power supply failedAC Restore AC Restore Mains power supply restoredAl Conf Dis K== Al Conf Dis K== Alarm confirmation disabled by lockswitchAl Confirm Z== Confirmed Z== Confirmed alarm on zone ==Alarm Abort U== Alarm Abort User aborted alarmAntiMask Al Z== Anti Mask Alarm Z== Anti-mask alarm on zone ==AntiMask Rs Z== Anti Mask Restore Z== Anti-mask alarm on zone == resetAntiMask Tp Z== Anti Mask Tamp. Z== Tamper on anti-mask zone ==ATE L.F. All ATE L.F. All Alarm Transmission Equipment: faulton all linesATE L.F. Rstr ATE L.F. Rstr Alarm Transmission Equipment: linefault(s) restoredATE L.F. Single ATE L.F. Single Alarm Transmission Equipment: faulton one lineAUX DC Fail AUX Trouble Auxiliary power failedAUX DC Fail Rstr AUX Restore Auxiliary power restoredBad Checksum EEPROM Failure Control unit memory corruptedBatt Flt Rstr Battery Restored Battery reconnectedBatt Load Fail Batt Load Test Fail Battery failed load testBatt Missing Battery Missing Battery disconnectedBell Tamper Bell Tamper Sounder tampered withBell Tamper Rst Bell Tamper Restore Sounder tamper resetBurg Z== Alarm Burg: Z== Intruder alarm on zone ==Burg Z== Rstr Burg Restore Z== Intruder alarm on zone == resetBypass Supr. Z== U== Sup. Bypass Z== Supervision on zone == bypassedCodes Defaulted Passwords Loaded Access codes returned to defaultvaluesIssue 1 71 of 76