Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769r2. Press Select.The display shows the first command in the menu:LnTo enter programming while the unit is operating:1. Open the 768r/769r case lid.Note: If the unit is connected to an alarm control panel the tamperalarm may sound.The display is blank.2. Press Select.The display shows the first command in the menu:LnLeaving Programming1. Press Set until the display shows one of the two letter commands.2. Press Select until the display shows the command "GO".You should see:GO3. Press Set.The display shows:CLYou should hear a single beep repeated slowly.4. Close the lid.The unit leaves programming mode after four seconds and clears thetamper indication.Note: There is a deliberate delay of four seconds before the receiver leavesprogramming mode to make sure that you have time to close the lidproperly and screw it down firmly.Restoring DefaultsIf you wish to remove all the programming from a unit (for example to reusean old unit in a new installation) then:1. Enter programming mode.2. Press Select until the display shows DL.3. Press Set until the display shows C1.4. Press Reset // on the front of the case. (You may need to use a smallblunt probe or similar to reach the switch.)The system gives a double beep.The unit is now ready to program.Note: You must carry out this procedure for each 768r/769r in an expandedinstallation.16 of 28 Issue 1