Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xKeypad Display Printed (9853 only)* MeaningU== Time/Date U== Reset Time/Date Time and date user reset the systemU== Z== Omit U== Omitted Z== User omitted zone ==U== Z== Unomit Zone Unomit Z== User unomitted zone ==UserCode req off UserCode req off K== No user code before installer codeUserCode req on UserCode req on K== User code before installer codeXT ACFl Rst Z== AC Fail Rstr Zone Z== Mains power supply restored in zone==XT ACFl Z== AC Fail Zone Z== Mains power supply failed in zone ==XT BatFl Rst Z== Batt Fault Rstr Zone Z== Battery reconnected in zone ==XT BatFl Z== Batt Fault Zone Z== Battery fault in zone ==XT Fault Z== Rst Fault Rstr Zone Z== Zone of type ‘Fault’ resetXT Fault Zone == Fault Zone Z== Zone of type ‘Fault’ activeXT LoBat Rst Z== Low Battery Low battery reset on radio zone ==XT LoBat Z== Low Batt Zone Z== Low battery detected on radio zone ==XT PwrFl Rst Z== Power O/P Fault Rstr Power output fault reset in zone ==Zone Z==XT PwrFl Z==Power O/P Fault ZoneZ==Power output fault in zone ==Note: The log is protected and cannot be erased by the Installer or a user.91 to 96: Testing OutputsYou may test parts of the system by entering commands at the keypad. Tocarry out a test make sure the system is in installer mode and then key inone of the following commands:91yTest normal outputs:On 975x units, press keys 1 to 3 to toggle outputs 1 to 3 on and off.On 9853 units, press keys 1 to 8 to toggle outputs 1 to 8 on and off.92y Test plug-by and plug-on outputs:Press key 0 to test the Alarm Transmission System.On 975x units, press keys 1 to 8 to toggle outputs 1 to 8 on and off.On 9853 units, press keys 1 to C to toggle outputs 1 to 12 on and off(A=10, B=11 and C=12).93y Not used.94y Test the internal sounder output.95y Test keypad functions.96y Not used.Press y to end each test. All outputs revert to their former settings.Note: An Alarm Transmission System (ATS) test includes the whole74 of 76 Issue 1