Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

Factory Defaults 8136Factory DefaultsWhen delivered from the factory, the 8136i is preprogrammed with thefollowing default settings:System UsersUO1: Name = User 01, Access Code 1234, Authority Level A,B,C,D,System Full Use, Zone omit Permitted, Log Access = Permitted,Change Area and Zone names = Permitted, Change Dataand Time = Permitted, Reset = PermittedUser 02-95: Not Used (Duress=Disabled)User 00: Name - Installer, Access Code = 7890Installer programmingMenu 10: Account Name = No NameMenu 20: Zone expansion = Default to whichever expander card isfittedMenu 30: Program zonesMenu 31: Zone Names = ZO1: Zone 001 (all other zones to Zone [nnn])Menu 32: Zone Options = All zones Not Used (NU)Menu 34: Area Names = Area 01: Area 01 (all other Areas to Area [nn])Menu 35: Program Partitions = None (No Areas Allocated)Menu 40: Program Multi-FlexMenu 41: Level Allocation = Level A,B,C,D = NoneMenu 42: Level Exit Mode = All Levels = Timed and terminate (Exit Time= 10 Seconds)Menu 43: Level Entry Time = All Levels 20 SecondsMenu 44: Level Flex-Zones = Not Set Up = NUMenu 45: Level Alarm response = All Levels = Full AlarmMenu 46: Level Re-Arm Operations = All Levels = NeverMenu 47: Keypad allocation = NoneMenu 48: Common Area DisabledMenu 49 Common Area Full Set Link = NoneMenu 50: Program outputsMenu 51: Program Output Type = OP1 = Bell (Normally Energised) Allother outputs NO FunctionMenu 52: Program Sounder = Follows BellMenu 53: Partition Bell times = Delay = 0, Bell Time = 20 MinutesMenu 54: Entry / Exit Tones = EnabledMenu 55: Lighting On Time = 2 MinutesMenu 56: Tamper Return = Single wire (closed circuit)Menu 60: Program System Options24 of 44 496339 Issue 4