Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

8136 Programming for IDISOR: For interfaces or SABs with a 2-pin PROG connector use a 3-way to 2-way Molex to Molex lead 485208. Connect the 2-pin Molex end onto thepins marked 'PROG' on the device. Ensure that the BLUE lead islocated on the pin marked with a star (*).OR: For IDIS sensors use the 3-way Molex to 2-way Molex lead 485208.Connect the 2-pin Molex end onto the detector's PROG pins. Ensurethat the BLUE lead is located on the pin marked with a star (*).Connect the red flying lead to the 12V terminal on the detector's IDISconnector.OR: For universal modules use the 3-way Molex to croc clip lead 485207.Connect the BLUE clip to the purple wire (Sig), black clip to the blackwire (0V), and red clip to the red wire (12V).7. Press Enter.The display shows (for example): IDIS LOOP NO 1PROG DEVICE Z009If the display shows any other message, see "IDIS ProgrammingErrors".8. Use the up and down arrow keys to select the correct loop number. Thesystem will change the zone number to the appropriate one for theselected loop. For example:IDIS Loop 1 contains zones 9 to 40, the display shows Z009IDIS Loop 2 contains zones 41 to 72, the display shows Z041IDIS Loop 3 contains zones 73 to 104, the display shows Z073IDIS Loop 4 contains zones 105 to 136, the display shows Z1059. Press Enter.The display shows (for example): IDIS LOOP NO 2PROG DEVICE Z041.10. Use the up and down arrow keys to select the appropriate zone number.(You can also key in a number in the range 09 to 40 (OR 136) to selectthe zone number directly.) Press Enter to confirm your choice.The display shows: IDIS LOOP NO 2PLEASE WAITFollowed by confirmation of the module's address,for example: IDIS LOOP NO 2DEVICE IS Z041496339 Issue 4 21 of 44