Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xCommandKey in:123 Report Restores 123ynyn = 0 Restores not reported Y1 Restores reported124 Reverse Open/Closed 124ynyn = 0 Off (disabled) Y1 On (reverse Channel 4)Note: Normally set to option1 in France.125 No Close Signal 125ynyn = 0 Off Y1 On: no close signal issent if more than one circuitis omitted126 Select Language 126ynnynn = 0 = EnglishY1 = Italian2 = Espanol3 = Port4 = Nederl5 = Francai6 = Deutsch7 = Norsk8 = Svenska9 = DanskX1 = Suomi127 This command is not used.128 Replaced by command 55.129 Telecommand Requires Entry 129ynyfor Unsetn = 0 External Unset Off Y1 External Unset On130 This command is not used.131 SIA Report Mode 131ynyn = 0 Basic Y1 Summary2 Intermediate3 FullCommandKey in:132 Send Tampers as Burglary 132ynyn = 0 Send standard SIAYmessages1 Send modified SIAmessages133 Do not Send SIA Restores 133ynyn = 0 Do not send SIAYrestores1 Send SIA restores134 AC Fail User/Installer Reset 134ynyn = 0 No Reset RequiredY1 User Reset2 Installer Reset135 Line Fault User/InstallerResetn = 0 No Reset Required1 User Reset2 Installer Reset136 Anti-Mask User/InstallerResetn = 0 User Reset1 Installer Reset135ynyY136yny137 AC Fail Override 137ynyn = 0 Never1 Inactive2 Any Y138 Line Fault Override 138ynyn = 0 Never1 If Only 1 Fault2 Any Y139 Fault User/Installer Reset 139ynyn = 0 User ResetY1 Installer Reset140 Fault Override 140ynyn = 0 NeverY1 Inactive141-42These commands are notused.YIssue 1 53 of 76