Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

IDIS Programming Errors 8136Note: An IDIS LIM contains the equivalent of five IDIS devices, numbered consecutively.When programming a LIM the system automatically assigns a block offive consecutive zone numbers. Therefore, program the first IDIS device in theLIM to the lowest zone number. Do not try to program the other four devices,the system will do it for you.11. Disconnect programmed IDIS module/sensor.12. Write the zone number on the device, so that it will be installed in thecorrect position.13. Repeat steps 4 to 12 for the other modules to be programmed.14. Press Menu when IDIS programming is complete.The display shows Menu 22.IDIS Programming ErrorsYou may see one of the following messages on the second line of the displaywhile programming IDIS modules/sensors. If so follow the procedure indicated.OUT OF RANGE The module is blank or incorrectly programmed.Carry on and try to program the module. If you donot succeed then use a new device and return theoriginal to the manufacturer.NOT IDIS ZONE You have tried to program a zone number less than9. Zones 1 to 8 are FSL zones.NO DEVICE FOUND There is nothing connected to the programmingpins on the IDIS Expander card.DEVICE FAULTY The system failed to program the device. Try againto program the module. If you do not succeed thenuse a new device and return the original to themanufacturer.FREQUENCY ERROR The device or module is not programmed correctly.Try again to program the module. If you do notsucceed then use a new device and return theoriginal to the manufacturer.NON SCANTRONIC The module is not a Scantronic IDIS device. Themodule cannot be used.22 of 44 496339 Issue 4