Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769r3. Press Set.The display shows the first channelnumber:C14. Press Select until the display shows a channel allocated to thetransmitter you wish to measure.The display shows, for example:C35. Press Set.The display shows the first device number on that channel: D16. Press Select until the display shows the device number of the detectoryou wish to measure.The display shows, for example:D47. Press Set.The display shows:CLYou should also hear a single "beep" repeated slowly from the768r/769r sounder.8. Close the case lid.The 768r/769r flashes the channel LEDs for that transmitter. All theother LEDs glow steadily.9. Trigger the transmitter.All channel LEDs glow steadily.10. Open the case lid.The display shows the device number alternating with the signalstrength.11. Press Esc/Del.The display shows:SGSignal Strength for All Devices (SA)1. Enter programming mode if the 768r/769r is not already there.The display shows:2. Press Select until the display shows the Signal All command.The display shows:3. Press Set.The display shows:You should also hear a single "beep" repeated slowly from the768r/769r sounder.LnSACLIssue 1 27 of 28