Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

734r1. External sensor zone 22. Alarm3. Tamper4. Note: Voltage free contact only.4k7Yellow, Geel, Jaune, Giallo, GulViolet, Viola, Fiolett, ViolettRed, Rood, Rouge, Rosso, Rød, RödGold, Goud, Or, Oro, Gylden, Guld, Gullen2k2Red, Rood, Rouge, Rosso, Rød, RödRed, Rood, Rouge, Rosso, Rød, RödRed, Rood, Rouge, Rosso, Rød, RödGold, Goud, Or, Oro, Gylden, Guld, GullenSelecting Operating ModeFigure 6.CommissioningTo use the 734r with a shock- or roller shutter sensor make sure that linkLK1 is open circuit (jumper NOT fi tted).ProgrammingWhen using the 734r as a roller shutter detector or as a shock sensor thenyou may program the detector’s sensitivity to events. To enter programmingmode short circuit LK4 by fi tting a jumper over both pins. The activity LEDfl ashes continuously while the transmitter is in programming mode. To leaveprogramming mode remove the short circuit from LK4 by fi tting the jumper toone pin only. Note that you do not need to program the 734r when using it asa door contact.Note: If the 734r refuses to enter programming mode (LED does not fl ash continuously)then the battery may be low. Change the battery and try again.Roller ShutterWhen using the 734r with a roller shutter sensor you can program the transmitterto transmit an alarm after a set number of open/close events on theroller shutter sensor. By default the 734r will send an alarm after detectingsix closures on the sensor. To change this number:1. Place the transmitter in programming mode.Issue 1 7 of 10