Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xKeypad Display Printed (9853 only)* MeaningPA Z== Alarm Panic Alarm Z== Panic alarm started in zone ==PA Z== Rstr Panic Restore Z== Panic alarm reset in zone ==RF Jamming Jamming Start Radio jamming detectedRF Jamming Rstr Jamming End Radio jamming resetRF Sup Fail Z== Supervision Fail Z== Radio supervision failure detected inzone ==RF Sup Rstr Z== Super'ion Restore Z== Radio supervision failure in zone ==resetSet Fail Z== U== Exit Timeout Z== System failed to set because of fault inzone ==Smk Det Alm Z== Smoke Det. Alarm Z== Smoke detector alarm in zone ==Smk Det Res Z== Smoke Det. restore Z== Smoke detector alarm reset zone ==Soak Fail Z== Test Zone Fail Z== Soak test failed in zone ==System Rearmed Rearmed System rearmed after an alarmSystem Startup Startup Power applied to systemSystem Tamp Rst System Tamp Restore System tamper resetSystem Tamper System Tamp System tamperTamper F== Rstr Forbi Tamp Restore F== Forbikobler keypad == tamper resetTamper K== Rstr Tamper K/P Restore K== Keypad == tamper resetTamper Z== Tamper Z== Zone == tampered withTamper Z== Tamper In Day Z== Tamper in zone == during the dayTamper Z== Rstr Tamp Restore Z== Zone == tamper resetTech Z== Alarm TA Z== Technical alarm in zone ==Tech Z== Rstr TA Restore Z== Technical alarm in zone == resetTel Line Fault Tel Line Fault Fault on telephone line (e.g. line cut)Tel Line Rstr Tel Line Restore Line fault reset on telephone lineTelecmd Low Bat Telecomm Low Battery Low battery in 723r telecommandTelecmmd PA Telecmd Panic Panic alarm from 723r telecommandTest Call Man Trig Test Test call madeTest Call Periodic Test Test call at a specified intervalU== # Set U== Armed L= User == set level/partition #U== # UnSet U== Disarm L= User == unset level/partition #U== Change U== U== Changed U== User == changed access code for user==U== Delete U== U== Deleted U== User == deleted access code for user==U== Dload Fail U== Download FAIL Download by user == failedU== Duress U== Duress Duress code entered by user ==U== Off-Site U== Prog. Mode End Installer exited from programmingmodeU== On-Site U== Prog. Mode Installer entered from programmingmodeU== Ptn # Reset U== Reset # User – reset partition #U== Remote Dload U== Download OK Download by user == successfulU== System Reset U== Reset User – reset systemIssue 1 73 of 76