Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xbottom edge of the keypad.2. Select which cable entry you are going to use and break out theappropriate plastic sections.3. Hold the backplate in place against the wall and mark the position ofthe centre hole in the adjustable cam (item 2 in Figure 7).4. Drill and plug the hole, and screw the backplate to the wall throughthe adjustable cam. Do not tighten the screw completely home.5. Make sure the backplate is level. Mark, drill and plug at least twomore fixing holes (item 1 in Figure 7). Screw the backplate to the wallthrough the holes.6. Cut the plastic webs connecting the cam to the backplate.Note: If you do not cut the webs, the tamper switch will not operate in theevent of the complete keypad being forced off the wall.7. Attach the front cover of the keypad (containing the keypad PCB) ontothe backplate and make sure that the tamper switch operates.8. If the tamper switch does not operate, rotate the cam until the switchoperates correctly with the front of the keypad mounted on thebackplate.112111. Fixing hole 2. Adjustable camFigure 7. Backplate of the 9930 EUR KeypadFitting the ScanProx 934 ModuleNote: If fitting a 934 module to an existing installation, put the alarm systeminto programming mode and then remove all power, both mains andbattery. If you do not remove all power, the system will not recognisethe 934 module.Issue 1 15 of 76