Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xCommand07 24-hour Alarm08 Strobe09 Smoke Sensor Reset10 French Siren Test11 Strobe Set (anypartition)12 Pulse Set 113 Pulse Unset 114 Alarm Confirmation15 Set Complete16 Unset Complete17 System AlarmIn a partitioned system:18 Bell Partition A19 Bell Partition B20 Bell Partition C21 Bell Partition D22 Strobe Set Partition A23 Strobe Set Partition B24 Strobe Set Partition C25 Strobe Set Partition D26 Pulse Set 127 Pulse Set 228 Pulse Set 329 Pulse Set 430 Pulse Unset 131 Pulse Unset 232 Pulse Unset 333 Pulse Unset 434 Fire35 PA36 Set Fail37 General Fault38 All FaultKey in:CommandKey in:82 Output 2 Type 82ynnynn = See Command 81 for a listof options.Default is 08 Strobe83 Output 3 Type 83ynnynn = See Command 81 for a listof options.Default is 03 Set Latch84 Output 4 Type – 9853 only 84ynnynn = See Command 81 for a listof options.Default is 04 ShockSensor Reset85 Burg Communication Rearm 85ynyn = 0 Latched Y1 Rearm86 Replaced by the changedcommand 2987 Keypad Dual Key Alarms 87ynynynyUse A or B keys to scroll through PA, FIand MD.n = 0 Off Y1 On (PA enabled)0 Off Y1 On (Fire enabled)0 Off Y1 On (Medical enabled)Note: Setting PA to option 1also enables a PA fromkeyswitches.88 Anti-Mask Mode 88ynyn = 0 Masking (4.4kΩ and 9.1kΩ) Y1 Masking (9.1kΩ) andFault (4.4kΩ)89 Alarm Confirmation 89ynyn = 0 None (default outside the (Y)UK)1 UK (DD 243) (default in (Y)the UK)2 Two zones50 of 76 Issue 1