Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

Setting Up Receivers and Transmitters 4618You should see the Power LED glow. If the sounder is connected youshould hear a short tone.For Systems Containing a 4618-501. For ALL units in the system set Mode Switch 2 (Power Mode)to OFF:on1 2 3 4 5 6 7 82. Connect the external 12V supply.You should see the Power LED glow. If the sounder is connected youshould hear a short tone.To Connect a Backup Battery1. Connect the battery lead spade connectors to the battery terminals(observing polarity)2. Connect battery lead connector to the Batt. In/Out connector on themain circuit card.Note: If the sounder gives a continuous tone when you apply power then the modeswitches are set to an unacceptable mode number. The 8-channel LEDs willalso show a running pattern of flashes. Set the Mode Switches to the requiredmode for your application.Setting Up Receiver And TransmittersTo make the 46RX family operate correctly you must set two groups ofswitches:1. The site code switch on both the transmitters and the 46RX familyreceiver to the same pattern.2. The mode switch on the 46RX family receiver to the correct mode.Figure 4 shows the switches in more detail.Figure 9. Site Switch and Mode Switch10 of 20 496371 Issue 1