Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769r12 Reserved for future use.13 Reserved for future use.14 PA15 Not used16 703r Four channel transmitter17 Two channel transmitter18 Tilt switchTable 2. Transmitter CodesTo use the Query command:1. Enter programming mode if the 768r is not already there.The display shows:Ln2. Press Select until the display shows: ??.3. Press Set.The display shows the first channelalternating with the transmitter code,for example: C1 08.If the channel has no transmitters thedisplay shows: C1 --4. Press Select to view the next channel.5. Press Esc/Del to leave the Query command.6. TestingAll signal strength testing must be carried out with the case lid closed.You can measure signal strengths either for a selected single transmitter, orfor all transmitters learned by the receiver.If you wish to test detectors learned by a 769r then ensure that the 768r isnot in programming mode.Signal Strength for One Device (SG)1. Enter programming mode if the 768r/769r is not already there.The display shows:Ln2. Press Select until the display shows the Signal Individual command.The display shows:SG26 of 28 Issue 1