Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769r2. Press Select until the display shows the Output Mode command OP.The display shows:OP3. Press Set.The display shows the first channel number:C14. Press Select until the display shows the channel you wish to change.The display shows, for example:C35. Press Set.The display shows the channel's current mode, for example: n56. Press Select repeatedly until the display shows the mode you wish toapply to the channel.The display shows, for example:n67. Press Set.The sounder gives a double "beep":The display shows:OPModes1 – MomentaryThe receiver switches the channel LED and relay ON for approximately fourseconds when it receives an ACTIVE signal from the transmitter. Thereceiver ignores RESTORE signals.2 – LatchedThe receiver switches the channel LED and relay ON when it receives anACTIVE signal from the transmitter and OFF when it receives a RESTOREsignal.3 – Manual ResetThe receiver switches the channel LED and relay ON when it receives anACTIVE signal from the transmitter. The receiver ignores RESTORE signalsand a user must reset the receiver to switch the channel OFF. The user cancarry out the reset either by pressing the reset button visible through the frontpanel, or by applying 0V to the reset input (for example from an attachedalarm control panel).4 – ToggleThe receiver switches the channel LED and relay ON when it receives anACTIVE signal from the transmitter and OFF when it receives the nextACTIVE signal.5 – Common TamperIf you program a channel to mode 5, and then learn a PIR or door contactinto any other channel, the receiver maps tampers to the first channel it findsset to mode 5.22 of 28 Issue 1