Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

4618 Modes 14 and 15Modes 14 And 15 - Transmitter Switch SettingsAt the transmitter:• Set switches 1 to 7 to the site code• Set switch 8 ON for device 1 or OFF for device 2.The receiver allocates four channels to each device. Channels 1 to 4 belongto device 1, channels 5 to 8 belong to device 2.MODE SW SETTING14 All Latching (2x4 Channels)on1 2 3 4 5 6 7 8on15 1,3,5,7 Momentary 2,4,6,8 Latching1 2 3 4 5 6 7 8Modes 16 To 18 - Transmitter Switch SettingsAt the transmitter:• Set switches 1 to 7 to the site code• Set switches 8, 9, and 10 to the channel number as follows:The receiver allocates one channel to each device.The receiver activates Common Output A (and the appropriate output channel)whenever any transmitter sends an ACTIVE signal on its channel A.The receiver allocates common output B to the channel B signals of all eighttransmitters. If the receiver receives ACTIVE signals on channel B from anytransmitter then it turns relay B ON. The receiver will only turn relay B OFFwhen all eight transmitters have sent RESTORE on their B channels.MODE SW SETTING16 1-4 Latching, 5-8 Mmt'y (Common B)17 1-4 Latching, 5-8 Mmt'y (A or B)18 All Latching, Manual Clearon1 2 3 4 5 6 7 8on1 2 3 4 5 6 7 8on1 2 3 4 5 6 7 8496371 Issue 1 15 of 20