Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5x9954 20mA typical, 30mA maximumRFX55mA934 15mA typical, 20mA maximumStandby battery(not supplied)17Ah, 12V rechargeable lead-acid, gel-type battery. Lowbattery voltage cutoff = 10V. Recommendedmanufacturers: Yuassa, Yucel or Fiamm.Note: To comply with the battery standby requirements of EN50131-1, thispanel requires AC mains fails to be communicated to an ARC. Whenusing PD6662, communicating AC mains fails to an ARC is optionalfor this panel. The maximum recharge time for a 17Ah battery is 24hrs (complies with Grade 3 requirements).OutputsOP 1 and 2 Voltage-free, single-pole relay contacts, rated 24VDC @ 1A.OP 3 and 4 Open-collector transistor output, 500mA, 12VDC, negativeapplied.OP 5 to 8* Open-collector transistor output, 50mA, 12VDC, negativeapplied.STSiren Test 14.4VDC (for use in France only)LSSupports two parallel-connected, externally mountedloudspeakers for internal sounder or EE tones: minimumspeaker impedance 16Ω.AUX 500mA, 12VDC minimum, 13.8VDC maximum, ripple ±2%maximum.12V logic outputs, negative applied in alarm (positiveremoved), 50mA maximum.Communicationsoutputs* These outputs are on the plug-by communicator. See "Fitting a PlugbyCommunicator" on page 34.InputsTRTamper return for BellTellback/Remote reset** +12V applied to operate reset.Line Fault input**+12V applied to indicate line failure.** These inputs appear as pins on the connector for the plug-bycommunicator. See page 34.FusesThe panel uses fast-acting polyswitch fuses for overcurrent protection:F1 – ST outputF2 – Battery test circuitF3 – 12V AUX output F4 – Battery outputF5 – Bus 1Note: Polyswitch fuses automatically reset when the load is entirelyremoved. The panel uses a T-250mA mains fuse.Issue 1 7 of 76