Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

535Connecting External Door Contacts or N.C. SwitchesYou can wire external Normally Closed devices to the 535r Universal Transmitter.You can connect several contacts in series, but the control unit will treatthem all as one zone. Do not use more than 10m total cable length from the535r to the last external contact.1. Remove the wire links from the connector block.2. Connect Normally Closed contacts wired as shown.Figure 5. Wiring the Universal Transmitter3. Make sure that the link opposite the internal reed switch is intact, unlessyou are using the reed switch as well.4. Check that each of the contacts activates the detector.Learning the DetectorTo learn the detector with the control unit see “ Learning Detectors” in the500r+ or 500r section.8 of 10 496362 Issue 1