Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769r4. Close the case lid.The channel LEDs for unused channels glow steadily. The LEDs forchannels with transmitters assigned flash.5. Trigger all the transmitters learned by the receiver.During the test once you have triggered all the transmitters belongingto a channel then the channel’s LED glows steadily. By the end of thetest all channel LEDs should be glowing steadily and the receiver willbeep to signal that it has detected all transmitters. If any channel LEDsflash then the receiver has not been able to detect one or moretransmitters belonging to that channel and you will not hear a beep. Ifyou open the lid before the end of the test then the receiver gives anerror tone.6. Open the case lid.The display shows the signal strength of the first device on the firstchannel,for example:C1 D1 S97. Press Select.The display shows the signal strength of the next device number onthat channel.8. Continue pressing Select.The display shows the signal strength of all the other transmitters, inchannel/device number order.9. Press Esc/Del.The display shows:SA28 of 28 Issue 1