Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

768r/769rThe display shows the first device number on that channel: D16. Press Select until the display shows the device number of the detectoryou wish to delete.The display shows, for example:D47. Press and hold Esc/Del for four seconds.The sounder gives a double "beep".The display shows:DLThe receiver removes all records of the transmitter from each channel thatthe transmitter occupies. You do not have to delete the transmitter from eachchannel in turn.Clearing a ChannelTo clear all transmitters from a channel:1. Enter programming mode if the 768r/769r is not already there.The display shows:Ln2. Press Select until the display shows the Delete command.The display shows:DL3. Press Set.The display shows the first channelnumber:C14. Press Select until the display shows a channel allocated to thetransmitter(s) you wish to delete.The display shows, for example:C35. Press and hold Esc/Del for four seconds.The sounder gives a double "beep".The display shows:DLThe receiver clears the selected channel, but retains records of transmitterson other channels. For example, if you clear a channel occupied by thetamper zone of a PIR, then the channel holding the alarm zone of the PIRcontinues to operate.Programming Channels (OP)Cooper Security Ltd recommend that you use the modes that the 768r/769rassigns to each transmitter by default during learning. However, if you havean application that needs to use some other mode, then you can changemodes for a channel as follows:1. Enter programming mode if the 768r/769r is not already there.The display shows:LnIssue 1 21 of 28