Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9448+/9448ESEngineer Walk TestEngineer Walk TestAllows the engineer to test all devices on the system.1. Enter programming mode.2. Key in "97 ENTER".The panel gives a continuous tone.3. Open and close each detector contact in turn.When a detector contact is open the panel gives an interrupted toneand fl ashes the zone LED.4. Press OMIT to stop the walk test.Note that the Engineer's walk test allows you to test all zones including PAzones, zone tampers, and panel and bell tampers. The user's walk test doesnot allow this.Set/Unset SystemPart SetOmit zoneKeypad PA 1 + 3Test BellsWalk TestChange User codeChime On/OffRead LogUser CommandsUser code2 + ENTER + User codeZone number + Omit (repeat for all zones to beomitted) + User code4 + ENTER + User code5 + ENTER User codeOmit to end test6 + current user codeCurrent user code againNew user code.7 + ENTER + User code8 + ENTER +User code> for later events496328 Issue 2 11 of 12