Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

IDIS 906Dimensionsh x w x d 210 x 210 x 65mm (Junior CombiBox).310 x 385 x 95mm (Euro Combi Box).WeightApprox 1kg without battery.QuiescentCurrent:230VAC 150mA max.Total Output:12V at 1A max continuous with fully chargedbattery.FusesPolyswitches.907EUR-50 power supply conforms to EN50131-6 Grade 3.Mains ConnectionAs the unit is designed to use mains 240 volts AC this connection should becarried out by a competent electrician to current IEE wiring regulations.ProgrammingBefore programming the 907 please ensure that there are no cables connectedto the unit. During programming the 907 draws power from the expandercard or programmer. The Mains Status and Aux DC LEDs flash.If using the Handheld Programmer connect the Prog pins on the 907 to 0V,12v and Sig on the Handheld Programmer. Use three-way molex to flyinglead part No. 485205.On an 8136 the IDIS zone number range is divided into four “loops” of 32zones each: 9-40, 41-72, 73-104 and 105 to 136. The 907 uses three zoneson the 8136 (see 8136-50 Installation Guide). If you make the zone numberof a 907 too close to the upper end of a loop range then the 8136 will notallow you to program that zone number. Do not try to program a 907 to thefollowing zones: 39, 40, 71, 72, 103, 104, 135 and 136.When the installation of all the equipment has been completed, return to thecontrol panel and program the 907 with:* zone type “IP”.* a zone Name and Area.Refer to Menus 31 and 32 in the Programming section of the manual 8136-50Installation Guide.NOTE: Scantronic recommend that you give the zone allocated to the 907 a validname, and allocate the zone to the Area in which it physically resides.496340 Issue 2 11 of 16