Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

“Call Out” to a Downloading Computer 8136When the Remote PC has completed downloading and signed off, thedisplay shows:DOWNLOADCOMPLETEfollowed by Menu 66.Connecting a Local PC to Use Downloader (Menu 66).The serial port can also by used as a link between a local PC and the system.The local PC can run and change the systemprogramming in the same way as a remote PC.Figure 13 shows the signals appearing at the pins of the serial port 9 pinconnector mounted on the end station PCB. The Figure also shows the pinsof a typical PC serial port, and the connections required in a cable to make alocal connection. Note that both ends of the cable should have female connectors.Control PanelNot connected. 1.Rx Data (input). 2.Tx Data (output). 3.+V (nominal 10V limited to 5mA). 4.0V. 5.Not connected. 6.CTS (output). 7.RTS (input). 8.Not connected. 9.PC Serial PortFemale 9 pin D-connector to female 9 pin D-connector1. DCD2. Rx Data (input)3. Tx Data (output)4. DTR5. 0V6. DSR7. RTS (output)8. CTS (input)9. Ring IndicatorFemale 9 pin D-connector to female 25 pin D-connectorNot connected. 1.Rx Data (input). 2.Tx Data (output). 3.+V (nominal 10V limited to 5mA). 4.0V. 5.Not connected. 6.CTS (output). 7.RTS (input). 8.Not connected. 9.1.2. Tx Data (output)3. Rx Data (input)4. RTS5. CTS6.7.8.9.....20.Figure 13. Signals on Pins of Serial ConnectorThe signalling parameters are: 4800 Baud, 8 bits, even parity and one stopbit.1. Select Menu 66 and press Enter.28 of 44 496339 Issue 4