Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

770rThe blue LED switches off. The sounder gives a regular beeping toneto remind you to replace the lid.2. Replace the lid (or operate the tamper switch).After a few seconds the red Trouble LED switches off and the soundergives a double beep confi rmation tone.Selecting MenusThe Module offers seven numbered programming menus that allow you tochange various aspects of the Module’s operation:MenuTitle1. Learn Transmitters.2. Delete transmitters.3. Select channel mode.4. Test signal strength.5. Select output relay polarity (NC/NO).6. Not used.7. Select operating mode.8. Restore defaults.A single blue LED glows to show which menu is active. To move betweenmenus press SELECT (see Figure 5).Menu:1 2 3 4 5 7 8SelectFigure 5.Note that the display skips over menu 6, which is not used.When you enter programming the Module starts at menu 1.Issue 1 11 of 30