Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

95EN, 85EN, 65ENcables should be checked for isolationto earth.12. Replace the cover of the control panel.13. Use the Engineer menu options to setup the system and test it.About Logging In As An EngineerLogging in as an engineer causes keypads connected directly to the samenetwork or MSNode to display "System Busy". Keypads connected to adifferent network or MSNode display ”Engineer on Site", and other engineersor users can log on to these.The factory default engineer code is 7890. If the system is set up for 6-digitcodes, the default is 789000.You will not be able to log in as an engineer if:• Another engineer or user is currently logged in at the keypad that youusing.• A user has fully set the system (i.e. all partitions armed).Note: You are able to log in if the system is partially set (i.e. not all partitions armed).This enables you to log in if, for example, the site has safes or other "strong"areas that are often armed throughout the day.• A user has prevented you from gaining access using User option 5-1.• The Hi Security Eng configuration option is selected and you do nothave a "remote reset" code.Logging OutIf you want to log out (i.e. exit from the Engineer menus completely), keeppressing ] until you see the following, then press [. Alternatively, selectoption 99 and press [.Press [ENT] toLeave MenusLogging out also logs out any other engineer currently logged in at a differentkeypad. If you have been using more than one keypad, this prevents youfrom having to check each keypad before you leave the site.44 of 72