Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xUsing a Partitioned SystemIntroductionWhen programming a control unit, there are two ways of changing from asingle system to a partitioned system:a) during initial power upb) using Command 98.To create a partitioned system during initial power up, refer to the 9x5xInstallation Guide.If you have an existing control unit that has already been programmed as asingle system and wish to convert it to a partitioned system, then:1. Enter installer mode.2. Press 98y at the keypad.The display shows:Load Default3. Press 1y at the keypad.The display shows (for example): Mult Sys? OFF4. Either:Press 1 to create a partitioned systemOr press 0 to create a single systemThe display shows (for example): Mult Sys? ON5. Press y.The keypad gives a double "beep" confirmation tone and the controlunit loads the default settings, erasing all previous selections.Programming PartitionsOnce you have selected a partitioned system, you can use the followingcommands to program each partition:1. Use Commands 01 to 16 and X17 to X40 to assign each zone to apartition.Each zone defaults to Partition A.Press A to assign zones to Partition A.Press B to assign zones to Partition B.Press C to assign zones to Partition C.Press D to assign zones to Partition D.2. Use Command 32 to assign each keypad to a partition as required.By default all keypads belong to all partitions.3. Program Exit Mode, Alarm Response and Exit Time for each partition:68 of 76 Issue 1