Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

Error Messages 8136General FaultsNo response from the keypad keys.• Check the keypad wiring.• Check the keypad address programming. See "Keypads".• Enter and leave programming mode.• Power up while shorting RST pins. (See "Resetting User and InstallerCodes".)No exit/entry tones from remote keypad• Check keypad is addressed correctly. See "Keypads".• Check that Keypad Sounder is ‘Enabled’. See "Keypads".• Check keypad is assigned to the Level being set (Menu 47).• Check if keypad faulty.Manual Connect from the remote PC fails to operate.• Check Secure Call Back is ‘Disabled’ (menu 73).Cannot remotely Set/Unset system• Check Remote Set/Unset ‘Enabled’. Refer to user Menu 3 - ‘SystemOptions’. (Note that the Installer Code does not allow you access toUser Menu 3.)Error MessagesAt various points in programming you may see error messages on thedisplay. The majority are self explanatory. The following list shows those thatare more obscure.Configuration Checking Error MessagesThe end station checks the configuration when you exit programming modeor when you apply power. If the end station finds a configuration error duringpower up it displays the message "CONFIGURATION ERROR CALL ENGI-NEER" at the keypad. The panel is unusable until you cure the problem.(Note that this will only occur if you have removed power from the end stationwhile in programming mode with a configuration error.)The end station will not let you leave programming mode until you have cureda configuration error.The first line of the configuration checking error message always shows thewords "CHECK CONFIG". The second line of the display may show one ofthe following:30 of 44 496339 Issue 4