Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

770r4. Use menu 1 to learn any transmitters you wish to use.Note that if you are learning a second transmitter then the Modulefl ashes the LEDs of channels already occupied.5. If necessary, use Menu 5 to change the polarity of the outputs. For the9651 in the example the outputs should be Normally Closed.6. Remove all power from the receiver Module.7. Connect the Module to the control panel. Figure 16 shows an exampleusing a 9651.8. Remove the jumpers for the outputs connected to the 9651.9. Power up the Module.Output connectionsWhen connecting the Module to a control unit, the outputs of the Moduleconnect to the inputs of the control unit. Use menu 5 to adjust the polarityof the outputs to suit the control unit inputs. In the example shown, the9651 uses CC normally closed inputs. The Module defaults to normally openoutputs. Use menu 5 to change the polarity of outputs 1 and 2 to normallyclosed. In addition, remove the jumpers for outputs 1 and 2.Figure 16.28 of 30 Issue 1