Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

9x5xcommunication system, from the Alarm Transmission Equipment(ATE) attached to the control unit to the communication equipment inuse at the Alarm Receiving Centre (ARC).97: Engineer Walk TestThis function enables the engineer to test all devices on the system.1. Enter installer mode.2. Press 97yThe display shows:97: Walk Test3. Open and close each alarm and tamper contact in turn.The system gives a Chime tone each time you open and close adetector contact. The display shows: "A: Zone" and the zone numberof every detector you have tested, in sequence and for one secondeach. If you also test the tampers on each zone, the display showsthe letter "T" against each zone number.4. Press X to stop the Walk Test.Note: The engineer Walk Test enables you to test all zones, including PAzones, zone tampers, and control unit and bell tampers. The userWalk Test does not enable you to test tampers or PA, Fire, 24-hourand Technical zones.199: Display Zone Circuit ResistanceThis command lets you step through the zones connected to the control unit,viewing the resistance of the circuit connected to each. Press A (down) andC (up) keys to step through the list of zones. The display shows: theresistance of the circuit in ohms (or O/C for open circuit), the zone type, andthe expander type.If you wish to go directly to a zone without scrolling through the entire listthen key in the two-digit zone number, for example 07 for zone seven or 19for zone nineteen.Issue 1 75 of 76