Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

739rProgrammingTo program the 739r you must make the receiver learn the transmitter’sidentity.For the 762r, 768r, 9955 and 9960, RFX or MRNode:1. Put the receiver into learn mode.2. Ensure the Activity LED jumper is fi tted to both pins on the 739r.3. Hold the 739r Activity LED pointing at the Learn LED of the receiver, atno more than 30mm from the Learn LED.4. Trigger an alarm or tamper at the transmitter.The transmitter sends its identity to the receiver using the Activity LED.For the 7510r:1. Put the 7510r into learn mode.2. Momentarily disconnect the tamper loop at the transmitter.The transmitter sends its identity to the 7510r by radio signal.Note:To improve battery life, Cooper Security recommend that you disable the ActivityLED by fi tting the Activity LED jumper to one pin only during normal use.4 of 4 Issue 1