Cooper TP Workshop Manual_Scant:Layout 1 7/8 ... - Cooper Security

IntroductionThe 720r Smoke Detector is designed to work with Scantronic 868MHz narrowband transmitters. The unit contains an integrated radio transmitter.SpecificationPart No. 720rEUR-00Power Supply 9VDC PP3 Alkaline battery (Energiser 522, DuracellMN1604)Low voltage alarm: 7.2VRF Immunity: 10V/mDimensions: 105mm x 105mm x 34mm (HxWxD)Operating Frequency: 868,6625 MHzRF Transmitter Power 10mWSpecifi cation subject to change without notice.InstallationInsert BatteryRemove the mounting plate (if fi tted) and connect a 9V (PP3) battery.1720r21. Hole for mounting flange2. Battery3. Learn LED3Figure 1.The activity LED fl ashes and the detector sounder gives a loud tone for onesecond. This tone indicates that the detector is working.Note: If the sounder clicks once a second then a fault has occurred or the battery istotally exhausted. Replace the battery and check that the sounder gives a onesecond tone.LearningPut the receiver into learn mode (consult the relevant section in the receiver’sInstallation and Programming Guide.)Radio Learning:Press and hold the test button for seven seconds.2 of 6 Issue 1